Used

1991 LIFETIMER 1950 WeatherMaster - NANAIMO

in Shamrock, SK

Seller note:

This boat and two motors are in excellent condition. They have been kept under cover most of the year except when used fishing in the summer months. Routine maintenance was performed on the trailer and motors.
Hull Design:
The hull design is a heavy gauge, all aluminum hull ideally suited for fishing. Length is 19.5 feet. Width is 8 feet. Exterior depth is 43? from the gunwale (side edge trim) to keel. Interior depth from side rail to floor is 26 ½?. Floor-boards are aluminum. Fuel tank capacity is 40 imperial gallons.
The Cabin:
The cabin is all aluminum and lockable. Equipped with four seats. Two front seats have storage compartments underneath. One of the back seats is a pedestal type and other is a box type with lift up lid and removable toilet below. The Dash has instrumentation for tilt, rpm, battery voltage indication, toggle switches for fore and aft sump pumps, battery selection, windshield wipers, air horn, and fuel indication.
Electrical Wiring:
The boat is wired for electric Scotty downriggers but the boat comes with manual downriggers. Also wired to fit two batteries so that one battery can be charged while the other is in use.
Main Motor:
The main motor is an electric start, 4-stroke [removed phone]HP Yamaha. This motor has only 28.5 original hours and runs like a dream.
Kicker (trolling) Motor:
The kicker is a 1994 Honda 9.9HP 4-stroke motor. A custom easily removable stainless steel linkage is included which can be used to link the main motor and kicker so that you can steer the boat from the cab while fishing
Trailer:
The trailer is a custom built heavy-duty trailer with side loading guides for easy loading of the boat onto the trailer. The brakes are drum with surge control. There are two winches; the main is electric and the backup winch is manual. There is also a spare tire mounted on the reach of the trailer.
Electronics:
The boat comes with a Garmin fish finder/depth-sounder and a CB radio.
Miscellaneous Items:
A custom metal saddle is available which fits the back end of boat near the transom to stabilize the boat should you need to jack the boat to remove the trailer.

Contact Seller:
By clicking here you have given permission for BoatVerse to transmit you information to seller/partner and for BoatVerse and/or seller/partner to contact you.

Check these out: